Application Information

EZ-PAM can be applied dry or wet, making installation simple and convenient.

For applying in a dry state, use a drop or broadcast spreader (equipped with an in-bin agitator or dynamic shaker) or hand cast.

Dry Applied	Flat Areas	Mild-Moderate Slopes	Steep Areas
lbs per 1000 sf	2.3	3.5	4.5
lbs per acre	100	150	200

For wet applications, EZ-PAM may be used by itself or as part of any standard slurry. Mechanical agitation equipment is required for proper mixing. Mixing is best accomplished using the following steps:

Fill the hydraulic seeder/mulcher at least half-full,
Add additional ingredients of a slurry, if applicable,
With agitation progressing, slowly sprinkle EZ-PAM into the water [3-5 minutes required],
After adding all EZ-PAM, allow continued mixing for a minimum of 3 minutes.

Wet Applied	Flat Areas	Mild-Moderate Slopes	Steep Areas
lbs per acre¹	100	150	200

¹ EZ-PAM must be applied with sufficient water to surface wet all soils. Typically, a 'surface wet' condition requires the application of approximately 3000 gallons of water per acre. Therefore, the mixing rates indicated in this table suggest that 100, 150 or 200 lbs of EZ-PAM should be added to a 3000 gallon tank and that the entire tank should be used on a one acre area. For smaller tanks, use an appropriate reduction of EZ-PAM. Similarly, for smaller areas, use a proportionate reduction in both water and EZ-PAM.

Contact your Regional Representative for addtional EZ-PAM information.

EZ-PAM is a trademark of Seva Enterprises, LLC

Solutions Grounded in Experience

Application Information